TX Knives

Functional handmade kitchen knives

230mm Stainless Kiritsuke

250.00
sold out
DSCF4609.jpg
DSCF4610.jpg
DSCF4615.jpg
DSCF4617.jpg
DSCF4618.jpg

230mm Stainless Kiritsuke

250.00
sold out

#93

Knife for Andre, Deposit deducted

Kiritsuke in high tech stainless powder metallurgy steel. It has been ground very thin, the thickness behind the edge is <0.1mm

The steel is Elmax from the Swedish company Uddeholm

 

Weight: 212g

Length overall: 355mm

Balance point: Under the X of the logo.

Blade

The blade has convex grind and is tapered from the bolster to the tip.

The spine and choil has been rounded to make the knife comfortable to use with a pinch grip.

 

Steel: Elmax

Elmax is a powder metallurgy stainless steel created by Bohler-Uddenholm. It is corrosive resistant due to its high Chromium percentage. It also has excellent edge holding capabilities. It is a fairly easy steel to sharpen and it becomes razor sharp due to the powder metallurgy process and the limited impurities.

 

Heat treatment: The blade has been differentially heat treated inhouse in a PID controlled furnace at 1100°C and quenched between thick aluminium plates. Finally it is tempered in a PID controlled oven to the final hardness.

 

Hardness: 61 HRC

Height at heel: 50.5mm

Thickness at

  • Spine at bolster: 2.2mm

  • Spine halfway: 2.1mm

  • 1 cm from the tip: 0.6mm

Handle

Material: Stabilized elm burl

Bolster and spacers: Stainless 304 bolster pinned to the blade with 304 pins, G10 and stainless spacers. Stainless 6mm 304 handle pin.
Treatment: The handle is sealed with Danish Oil

Add To Cart

#93

Knife for Andre, Deposit deducted

Kiritsuke in high tech stainless powder metallurgy steel. It has been ground very thin, the thickness behind the edge is <0.1mm

The steel is Elmax from the Swedish company Uddeholm

 

Weight: 212g

Length overall: 355mm

Balance point: Under the X of the logo.

Blade

The blade has convex grind and is tapered from the bolster to the tip.

The spine and choil has been rounded to make the knife comfortable to use with a pinch grip.

 

Steel: Elmax

Elmax is a powder metallurgy stainless steel created by Bohler-Uddenholm. It is corrosive resistant due to its high Chromium percentage. It also has excellent edge holding capabilities. It is a fairly easy steel to sharpen and it becomes razor sharp due to the powder metallurgy process and the limited impurities.

 

Heat treatment: The blade has been differentially heat treated inhouse in a PID controlled furnace at 1100°C and quenched between thick aluminium plates. Finally it is tempered in a PID controlled oven to the final hardness.

 

Hardness: 61 HRC

Height at heel: 50.5mm

Thickness at

  • Spine at bolster: 2.2mm

  • Spine halfway: 2.1mm

  • 1 cm from the tip: 0.6mm

Handle

Material: Stabilized elm burl

Bolster and spacers: Stainless 304 bolster pinned to the blade with 304 pins, G10 and stainless spacers. Stainless 6mm 304 handle pin.
Treatment: The handle is sealed with Danish Oil